Wacom CTF-220 Instrukcja Użytkownika Pobierz pdf (Strona 34)

XT[2] Series DISK RECORDER

Version 10.04 - Hardware

Technical Reference Manual

Issue

10.04.A

EVS Broadcast Equipment

–

January 2011

o i=2.5 to 30 mA -> opto ON

o imax= 30 mA

• Direct connection to a TTL/CMOS signal possible (Pin opto - to GND and pin

opto + to the TTL/CMOS signal.

Typical switching point @ 1.6 Volts, for secure operation:

o Vin< 0.8 Volts -> opto OFF

o Vin> 2.2 Volts @ 2 mA -> opto ON

o Vin max (without external resistor) = 15 Volts

4 X CMOS Input/Output:

•

each pin can be individually configured as an output or an input

• internal 4K7 pull up to +5V

• low level Vi<1.5 Volt (U12=74HC245)

• high level Vi>3.5 Volt (U12=74HC245)

• optional TTL compatible level (U12=74HCT245)

2.6 RS422 CONNECTOR

The RS 422 cable must be wired PIN TO PIN following the above diagram. Use

shielded cable to avoid electromagnetic interference on long distances.

Important

The Reset command from the Remote is sent through the Pin n°5 of

RS422 connector. This function should be disabled when the controller

on RS422 #1 is not an EVS controller

(refer to the section ‘MTPC Board’

on page 58 of this manual).

The technical specifications for the RS422 connector are the following:

• 19200 bauds

• No parity

• 8 data bits

• 1 stop bit

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Brak uwag

Wacom CTF-220 Instrukcja Użytkownika Strona 34